Rupes HR81M Manual De Instruccion página 11

DANGER: The indicated measurements refer to new power tools. Daily usage causes the noise and
vibration values to change.
MAINTENANCE AND SERVICING
WARNING: To reduce the risk of injury, turn unit off and disconnect it from power source (when
machine is connected to a power supply) or battery pack (when machine is connected to a battery
pack) before installing and removing accessories, before adjusting or when making repairs. Be
sure the switch is in the "OFF" position. An accidental start-up can cause injury.
CLEANING
At the end of each work session, or when required, remove any dust from the body of the tool using a soft cloth,
paying particular attention to the motor ventilation slots. No other maintenance operations must be undertaken
by the user.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal
operating conditions. No further lubrication is necessary.
REPAIRS
Maintenance and cleaning of the inner parts like ball bearings, gears etc. or others, must be carried out only by
an authorized customer service workshop.
DISPOSAL (WEEE DIRECTIVE)
FOR EU COUNTRIES ONLY: According to the European Directive on Waste from electrical and
electronic equipment and its implementation in conformity with national standards, exhausted electrical
equipment must be collected separately, in order to be recycled in an environmentally friendly way. The
product, when it reaches the end of its life, must not be dispersed in the environment or thrown away
as household waste. It must be disposed at authorized recycling centres (contact your local authorities
to know where to dispose of the product according to the law). The correct disposal of the product
contributes to the health and preservation of the environment. Illegal disposal of the product will entail
penalties against the offenders.
Rupes BIGFOOT NANO iBrid tool Part Numbers:
HR81M
HR81ML
9HC120LT
9HB120LT/9HB125LT
9HP120LT
WARRANTY
Complying with current applicable regulations and subject to more favorable conditions that could apply in
different countries, RUPES professional tools are supplied with a 12 months warranty against manufacturing
defects from date of purchase. Only Rupes original parts and accessories must be employed with RUPES tools.
Rupes is not responsible for any damages or accidents caused by not abiding to this rule and the warranty shall
terminate if non-original parts are employed. Damages caused by natural wear and tear, overloading, faulty
maintenance and tool usage differing from the one specified in the user guide, are not covered by this warranty.
A tool which has been proven faulty must be delivered to an authorized Rupes service center along with its fully
filled out warranty certification and document of purchase. Warranty shall be void if tool should be delivered
disassembled or tampered. This warranty does not in any way imply tool's replacement. RUPES S.p.A. reserves
the right to make specifications or design changes to its products without further notice. RUPES does not accept
any responsibility for any possible printing mistake. This document supersedes all previously printed one.
FREE LABEL REPLACEMENT: If your labels become illegible or are missing, call 0039 02 94 694 1 RUPES
S.p.A. for a free replacement.
- short neck Rupes BIGFOOT NANO iBrid tool
- long neck Rupes BIGFOOT NANO iBrid tool
- Li-ION Battery Charger
- Li-ION Battery pack
- Rupes BIGFOOT NANO iBrid tool Power Supply
11 11