Publicidad
Idiomas disponibles
Idiomas disponibles
- Let the appliance running with no load for 30 seconds
in a safe position. If you notice serious vibration or
other defects stop the appliance immediately. Then
check the problem and /or proceed as we describe on
Anomalies and Repair clause.
- Adapt the settings of your power tool to the respective
application. For example, reduce the stroke rate and
orbital action when cutting metal or for tight curved
cuts.
- Always check the workpiece before operation and
remove any obstructions such as nails, staples,
screws, string, rags, cloths and other debris.
- Check the position of power cables before
commencing work ensuring they are well away from
the work area.
- Keep hands and other body parts well away from the
work area whist the tool is in use.
Description
A
Start-up switch
B
Lock Button
C
Jig Saw Blade
D.
Shoe
E
Dust extraction connector
F
Retaining lever
G
Guide roller
H
Set of screws
I
Allen Wrench
J
Saw blade holder
K
Dust extraction adaptor
L
Electronic Regulation Control
M
Pendular regulation
N
Protective Cover
Instructions for use
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Before use:
- Make sure that all the product's packaging has been
removed.
- Prepare the appliance according to the function you
wish to use:
Fitting the accessories (Fig.2)
- Unplug the appliance from the mains.
- Raise the protective Cover (N).
- Rotate the retaining lever (F) and maintain it in this
position
- Clean the shank of the saw blade before inserting it.
An unclean shank cannot be fastened securely.
- Insert the jig saw blade up to the stop in the saw
blade holder (J)
- Make sure that the back of the saw blade engages
in the slot of the guide roller (G)
- Release the retaining lever (F) and press the saw
blade until the retaining lever (F) returns to its original
position.
- Lower the protective Cover (N).
- Regularly check that the saw blade is fastened
Pendulum mechanism adjustment (Fig.1)
- The pendulum mechanism provides blade swivel
motion with improved cutting and higher work speed
per material.
- To adjust the pendulum mechanism use the control (M)
- At position (0) there is no swivel
- Pendulum movement is increased from position 1
to position 3.
- Change of setting can be carried out with the
machine in motion.
Electronic speed control (Fig.1):
- The speed of the appliance can be regulated by
using the speed regulator control (L). This function
is very useful, as it makes it possible to adapt the
speed of the appliance to the type of work that needs
to be done.
- If the appliance works continuously at low speed,
working life of the appliance will be reduced
considerably.
Use:
- Before connecting the power cord to the mains
power supply ensure the switch is in the off position.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off switch (A)
Failure to do so may cause a blade breakage
resulting in a serious injury.
- Allow the jig saw to reach it's maximum speed
before commencing work
- To activate this function press button (B) while
holding down the start-up switch (A).
- To deactivate this function press the start-up (A)
switch right down.
Cutting of mitre angles (Fig 3):
- Loosen the set off screws (H) using the Allen wrench (I)
- Tilt the shoe (D) to the required miter angle. (0-45º
left or right).
5
Publicidad
