Assembly; Packing List - Homelite UT40520 Manual Del Operador

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
NOTE: This tool is heavy and requires two people to lift.
To avoid back injury, keep your knees bent and lift with
your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-242-4672 for assistance.

PACKING LIST

Water Pump
4-Cycle Engine Lubricant (SAE 30 or SAE 10W30)
Hose Clamps
Spark Plug Wrench
Strainer
Operator's Manual
NOTE: Suction and discharge hoses (not included)
are needed for operating this tool. Look for these
items where you purchased this product or visit
www.homelite.com.
DANGER:
Make sure you use a long enough hose or combinations
of hoses to keep the water pump at least 20 feet away
from homes, buildings, basements, open windows,
doors, and vents with the engine exhaust directed away.
Engine exhaust contains Carbon monoxide, a colorless,
odorless, and extremely dangerous gas, can cause
unconsciousness or death.

ASSEMBLY

WARNING:
If any parts are damaged or missing do not operate
this water pump until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this water pump or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
Never install parts or make adjustments to the water
pump while the engine is running. To prevent accidental
starting that could cause serious personal injury, always
disconnect the engine spark plug wire from the spark
plug when assembling parts.
INSTALLING SUCTION AND DISCHARGE
HOSES (NOT INCLUDED)
See Figures 2 - 5.
NOTICE:
Never use hoses with inner diameters smaller than 2
in. Smaller hoses will not seal properly and will make it
harder to obtain suction.
To attach suction hose to pump:
 Assemble the strainer.
 Attach one end of the suction hose (not included) to the
strainer using a hose clamp.
 Screw the other end of the suction hose onto the pump
inlet. Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the hose to leak during use.
 Pull on the hose to be certain it is properly secured.
Page 10 — English