Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Insignia NS-PDP42/50-09 Plasma TVs
PC mode problems
Problem
Solution
The signal is out
• Adjust the resolution, horizontal
of range
frequency, or vertical frequency.
• Check the input source.
Vertical bar or
• Adjust the clock, phase, or
stripe on the
horizontal/vertical position, or try Auto
background,
to configure these options.
horizontal noise,
or incorrect
position
The screen color
• Check the signal cable to make sure that
is unstable or a
it is connected correctly.
single color
• Reinstall your PC's video card.
Specifications
Dimensions
With stand
NS-PDP42-09
Without stand
Dimensions
With stand
NS-PDP50-09
Without stand
Weight
With stand
NS-PDP42-09
Without stand
Weight
With stand
NS-PDP50-09
Without stand
Power
Input - NS-PDP42-09
requirement
Input - NS-PDP50-09
TV system
NTSC-M, ATSC 64 and 256 QAM
Program
VHF 2-13, UHF 14-69, CATV 1-135, DTV 2-69,
coverage
CADTV 1.135
External
75 ohms
antenna
impedance
Environment
Operating temp.
Operating humidity
Storage temp.
Storage humidity
40.9 × 28.7 × 12.1 inches
(1040 × 729 × 3080 mm)
40.9 × 26.6 × 3.2 inches
(1040 × 677 × 83.6 mm)
48.2 × 33.4 × 14.3 inches
(1224.7 × 849 × 364 mm)
48.2 × 31.1 × 3.2 inches
(1224.7 × 790 × 83.6 mm)
57.3 lbs. (26 kg)
52.9 lbs. (24 kg)
91.4 lbs. (41.5 kg)
83.9 lbs. (38.1 kg)
100-120V AC, 50/60 Hz
100-240V AC, 50/60 Hz
32~104°F (0~40°C)
Less than 80%
-4~140°F (-20~60°C)
Less than 85%
www.insignia-products.com
Legal notices
FCC Part 15
This device complies with Part 15 of the FCC Rules.
Operation of this product is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply within
the limits for a class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced technician for
help.
37
Publicidad
Tabla de contenido
