Cleaning And Maintenance - cecotec BOLERO DRESSCODE 7200 Manual De Instrucciones

ENGLISH
20 ºC 3.5
Spin 7.0
Programmes are available according to the laundry type.
Programmes
Cotton Hard-wearing textiles, heat-resistant textiles made of cotton or linen.
Synthetics Wash synthetic articles, for example shirts, coats, mix. While washing
the knitting textiles, detergent quantity shall be reduced due to its
loose string construction and easily-forming bubbles.
Wet & Dry Mixed load consisting of textiles made of cotton and synthetics.
20 ºC 20 ºC default, can choose cold water.
Express 15' Extra-short programme, suitable for lightly soiled washing or for
small amounts of laundry.
Rapid 45' This programme is suitable for washing not very dirty clothes, saves
more energy and water.
60´ Wash This programme is suitable for daily wash, for daily laundry, to
achieve a good washing performance in about 60 min.
ECO 40-60 Default 40 ºC, not selectable, suitable for laundry washing at about
40 ºC-60 ºC.
Wool Hand or machine-washable wool or rich-wool textiles. Gentle
washing programme to prevent shrinkage, longer programme pauses
(textiles rest in wash liquor).
Spin Extra spin with selectable spin speed.
Intensive To increase the washing effects, washing time is increased.
Sterilization mode Keeps the washing temperature above 60 ºC for more than 30
minutes to effectively remove harmful bacteria.
Delicate For delicate, washable textiles, e.g. silk, satin, synthetic fibres or
blended fabrics.
Sport This programme is suitable for washing the sportswear.
Rinse & spin Extra-rinse with spin.
Warnings
- After a programme is completed, wait for two minutes before opening the door.
- Check whether the water inside the drum has been drained before opening its door. Do not
- Open the door if there is any water visible.
- Never stop the device before the end of the drying cycle unless all items are quickly
72
4.0 1:01
8.0 0:12
removed and spread out so that the heat is dissipated.
- Do not wash only one piece of clothes or garment, as these could cause great unbalance.
Always introduce at least 3 or 4 clothes so that draining can be done smoothly.

5. CLEANING AND MAINTENANCE

Warning
- Before cleaning or maintaining, unplug the appliance and close the tap.
- Proper maintenance on the washing machine can extend its working life. The surface can
be cleaned with diluted non-abrasive neutral detergents when necessary. If there is any
water overflow, use a cloth to wipe it off immediately.
Fig. 25.
- Do not use abrasive cleaners or scouring pads to clean the product.
Cleaning the drum
- The rusts left inside the drum by the metal articles shall be removed immediately with
chlorine-free detergents.
- Do not use steel wool.
Note
Do not put laundry in the washing machine during the drum cleaning.
Cleaning the door seals and glass
- Wipe the glass and seal after each wash to remove lint and stains. If lint builds up it can
cause leaks.
- Remove any coins, buttons and other objects from the seal after each wash.
Fig. 26.
Cleaning the inlet filter
Note
The inlet filter must be cleaned when there is little water.
Washing the filter in the tap
Fig. 27.
1. Close the tap.
2. Remove the water supply hose from the tap.
3. Clean the filter edge.
4. Reconnect the water supply hose.
BOLERO DRESSCODE 7200 / 7200 STEEL / 8200 / 8200 STEEL
ENGLISH
73