Charging The Device - A&D Medical PREMIUM WIRELESS Manual De Instrucciones

USING THE MONITOR

Charging the Device

Battery may be partially charged but be sure to charge the
device completely upon first use after purchase.
1. Remove the USB connector cover.
2. Connect the charging cable.
3. During charging, the red LED will illuminate.
4. When charging is complete, the red LED will turn off.
5. Once charging is complete, remove the charging cable.
•
The battery life varies with the ambient temperature and may
be shorter at low temperatures.
•
Please use the specified charging cable included with the device.
•
Blood pressure measurement cannot be done during charging.
•
When disconnecting the charging cable from the blood pressure
monitor, grasp and pull the charging cable out of the connector.
•
Do not connect to equipment other than those specified.
•
Do not replace the battery.
•
It is recommended to charge the battery periodically even
during storage. If the battery can no longer be charged, please
contact customer service.
•
Overcharging the battery may reduce its lifetime.
•
Lithium battery replacement by inadequately trained personnel
could result in a hazard such as a fire or explosion.
E-12
CAUTION!