Fitting Out The Tool Drum; Connecting Dust Vacuuming Equipment; Water Connection - Von Arx DTF 25 SH Instrucciones De Manejo

DTF 25 SH • Operating Manual

Fitting out the tool drum

Removing the cutters
1. Detach the hexagon nuts from the tool drum retaining ring.
2. Remove the retaining ring from the tool drum.
3. Pull the blades and the spacers out of the drum core.
Choosing the type of blade
The blades must not be mixed on a single tool drum.
Two blades must not be mounted next to each other.They must always be separated by a
spacer.
Diamond blades should only be replaced in sets.
Fitting out the flail shafts
4. Push the diamond blades and the spacers onto the core of the drum (Attention: sense of
rotation)
5. Push the friction washer onto the tool drum and fasten with hexagonal nuts
1
4

Connecting dust vacuuming equipment

The suction hose with camlock fitting of 3" can be connected directly onto the extractor pipe of
the housing.
Side attachment (option)
The suction hose with an inside diameter of 50 mm can be connected directly onto the extractor
pipe of the housing

Water connection

If possible one should work with water cooling (durability of the diamond blades)
• Water connection to the ball valve with a male quick connection "Gardena" and put round the
lever (90°)
• Working with the side attachment: remove quick coupling from DTF-25 SH at the front left
and couple at the side attachment on the right.
10
2
5
Operation
3