Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL DESCRIPTION AND PRINCIPLE OF FUNCTION
Installation of the machine
1. Driving motor
2. Spray tod (water cooling)
3. Dust suction end connector
4. Emergency stop switch
5. Steering device: foot pedal down: easily
maneouvring (rear wheel lifted. Pedal up:
working position (engine off) --> braking
effect parking position)
6. Operation handle (for hydraulic advance)
stopps if letting go of.
7. Handwheel (Depth adjustment with scale)
8. Steering handle
9. Fatigue protection (Secure to the machine
operator's wrist. Automatically interrupts
the machine energy supply if the machine
operator is no longer able to control the
machine.
10. Drive wheels (Are connected directly to
hydraulic advance)
11. Belt guard (Safety device)
12. Propulsion lever (Directional and speed
indication)
13. Transport hooks (Fixing points for crane)
14. Tool drum
15. Motor switch:
• 400 V / 50 Hz motor: (0=off, Y=Star circuit
(set to Y 10 seconds after switching on)
(Δ Delta circuit=operation position
• 480 V / 60 Hz motor: 0-1 position with softstart.
Mode of operation
Mode of operation
The surface treating machine works with a rotating tool drum. The tool drum can be tipped with
different diamond blades for hard, brittle hard and solid or viscoplactic floors.
The machined surface is cut with the diamond blades rotating of the tool drum.
Steering
Machines with a hydraulic advance are provided with a steering device to ensure the manoeu-
vrability at idle motor. Through pressing down the foot pedal the rear wheels are lifted from the
ground and the machine can be manoeuvred easily onto the guide rollers.
15
4
7
13
3
1
14
6
9
8
12
2
5
10
11
15
Publicidad
Tabla de contenido
