Final Operations; Care And Maintenance; Maintenance Plan - Von Arx DTF 25 SH Instrucciones De Manejo

DTF 25 SH • Operating Manual
In the event of incorrect use, the milling capacity is reduced and the tool unnecessarily
stressed and worn.
The surface quality after machining depends essentially on the chosen tools and the fit-
ment method.
To obtain straight grooves, traces etc. a cord may be laid out on the floor or beam
may help.
Levelling and coating removal work can also be performed with forward and backward
movements of the machine.
Before continuing to work surfaces that have already been treated, brush them down with a
broom and clean with a powerful vacuum cleaner.

Final Operations

Stop the machine
1. Lift the tool drum off the ground
2. Switch off the drives.
3. Machine now stationary.
4. Interrupt the energy supply by disconnecting the power cord (models with electric drive).
Switch the dust extraction system off
1. Switch the dust extraction system off.
2. Remove the suction from the machine.
Remove water connection
1. Stop water intake
2. Remove water connection
Storing the machine
The machine should be cleaned after each use!
1. Clean the machine.
2. Store the machine in a dry place.
Transport must be effected by means of belts or with 4 rope hooks provided for this purpose!

CARE AND MAINTENANCE

Maintenance plan

The machine has been specially designed to reduce the time needed for maintenance work to a
minimum. However, some maintenance work is essential!
This will enable the machine to operate in a troublefree manner and give you good service for
many years.
Always interrupt the energy supply before performing maintenance work.
Remove the mains plug
Daily or after every 10 hours of operation:
• Clean the outside of the machine� (do not use solvents)
• Blades, Flail shafts, Check the condition of the spacers (remove the tool drum, replace
worn parts)
• Hydraulic oil level-hydraulic traction (check, top up if necessary with: 10 SAE 40 W) Please
perform at weekly intervals after the first week.
Weekly or after every 50 hours of operation:
• Check the bearings (Arrange for aftersales service to change damaged bearings)
• Check bolts (Tighten any loose bolts, arrange for aftersales service to change any damaged
assemblies)
• Check the dust aprons (Replace damaged or worn dust aprons)
• Clean the dust extraction connection
• Lubricate the adjusting device (Check the functions after cleaning and lubricating)
12
Care and maintenance