Note: Hand-Arm Vibrations; Use For The Intended Purpose; Residual Risk; Safety And Responsibility At Work - Von Arx DTF 25 SH Instrucciones De Manejo

DTF 25 SH • Operating Manual

NOTE: Hand-arm vibrations

Working with the DTF 25 SH leads to vibration stressing. Please follow the legal provisions as
regards the permitted operating time.
Safety stickers on the machine
WARNING: CUTTER SHAFT
WARNING: ELECTRIC SHOCK HAZARD
EAR PROTECTORS MUST BE WORN
Damaged or lost safety stickers must be replaced immediately! These stickers are obtainable
from your Customer Service Center.

Use for the intended purpose

The machines are designed exclusively to treat horizontal surfaces. Any other use does not
correspond to the intended purpose. The manufacturer declines all liability for damage caused
thereby. Surface preparation machines always attack the surface to be treated. They are
therefore not suitable for cleaning sensitive surfaces (such as tiled floors) (see also "Field of
application" on page 7).

Residual risk

There is still a residual risk owing to differing characteristics of the floor coverings, even if the
machine is used in accordance with applicable regulations.
If you detect irregular cutting, you must reduce the working depth or check the cutting drum
and blades.

Safety and responsibility at work

• Make your contribution to safety at the workplace.
• Report any discrepancy deviating from normal working immediately to the responsible
person.
• Perform all the work with an awareness of the need for safety.

Further safety instructions

Make sure to comply with your local or national regulations, standards and directives.

FIELD OF APPLICATION

Depending on the blade type, hard, brittle to firm or elastic surface materials can be worked
e.g.:
• Asphalt and cast asphalt surfaces
• Concrete and cement, synthetic stone, floor tiles
• Screeds of cement, wood cement, ceramic etc.
• Natural stone
• Thermoplastic materials
Surfaces made of highly elastic soft materials or fabrics and fiber materials cannot be worked,
or can only be worked with certain limitations e.g.:
• Latex, rubber, soft plastics and foam materials
• Wood, carpets and woven materials
Field of application
WARNING: HOT SURFACE
STUDY THE OPERATING MANUAL
SAFETY SHOES MUST BE WORN
7