KTM 90212932000 Instrucciones De Montaje página 20

5 ASSEMBLY
5.1
8
Assembly
Info
Assembly at an authorized specialist workshop is recommended.
502892-01
502893-01
502894-01
–
8
Remove screws .
Guideline
9
If spacers are installed between the axle clamp and the
brake caliper on some models, these are not to be removed
under any circumstances.
–
1
Mount brake disc lock
included) and tighten.
Guideline
Screw, brake M8x80
disc lock with
ABS
Screw, brake M8x75
disc lock
without ABS
Info
For vehicles without ABS, spacer bushings
6
screws (all included) must be used.
Operation
–
3
Insert key (included) into locking cylinder
unlock.
–
2
Mount locking bolt
–
Turn the front wheel until the locking bolt engages in the
brake disc.
–
Lock or unlock with key
Info
The Roadlok must be registered in order to be able
to reorder a key. For this you need the VIN of the
vehicle and the serial number of the keys, which is
located on the tag on the key. This is possible via
customer service or at www.roadlok.com/registration
International customer service:
support@roadlok.com
7
with screws and spacers
27 Nm (19.9 lbf ft)
Loctite ®
30 Nm (22.1 lbf ft)
Loctite ®
5
and
A
and
(included).
3
.
4
(all
243™
243™