General Safety Instructions; Personal Protective Equipment; Filling And Emptying The Pan Oil Or Fat - Rational RAT-60.74.941 Manual De Instrucciones

3 | General safety instructions

3 General safety instructions
The unit is designed to be safe and will not
present any danger if used in a correct and
proper way. These instructions describe
how to use the unit correctly.
Safety instructions before use
Make sure that the supply cable of the
n
oil cart is not near hot surfaces or on
any heating surfaces.
Safety instructions during use
Only switch the pump on if you have
n
swivelled the outlet pipe over the pan
or a container.
Only switch the pump on if there is li-
n
quid oil or fat in the oil cart. Other-
wise, the pump can overheat and be
damaged.
Never switch the pump on when there
n
is water in the oil cart. Otherwise, the
pump can be damaged.
Observe the minimum filling quantity
n
of the oil cart of 15 litres. Do not allow
the the minimum filling quantity to be
dropped below when heating oil or fat.
Observe the maximum filling quantity
n
of the oil cart of 49 litres. Do not ex-
ceed the filling quantity.
Regularly change oil or fat. Old oil or
n
fat is highly flammable and has a tend-
ency to overflow.
If you pump hot oil or fat from the oil
n
cart into the pan, the outlet pipe will
become very hot. Only handle the oil
cart using the handles.
If oil or fat spills onto the floor when
n
loading or emptying the pan, clean the
floor immediately. The floor around
the unit must be dry and slip-resistant.
80.06.602 Original instructions

3.1 Personal protective equipment

Wear protective gloves for reliable
n
protection when handling hot objects
and sharp-edged trays.
4 Filling and emptying the pan
oil or fat
Use the oil cart to easily fill and empty the
pan with oil or fat. Using the oil cart, you
can pump oil or fat into the pan at a max-
imum temperature of 180 °C. After frying,
you can pour the oil or fat back into the oil
cart.
Filling the oil cart
a
The drain opening is closed.
1. Open the lid of the oil cart.
2. Pour the desired amount of oil or fat
into the oil cart. Observe the minimum
and maximum permissible fill quantit-
ies of the oil cart from 15-49 L.
Melt solid fat
a
There is at least 15 litres of solid fat in
the oil cart.
1. Set the heater switch from 0 to I.
>
The fat is heated at 80 °C and becomes
liquid. The pump does not work while
the heater is running.
2. When the fat is liquid, set the heater
switch from I to 0.
>
The heating is switched off. Now you
can fill the pan with fat.
Filling the pan
a
There is liquid oil or fat in the oil cart.
1. Take the oil cart to the unit.
2. Swing the outlet pipe over the pan, so
that oil or grease can safely run into
the pan.
en
13 / 80