Interrupting The Cooking Process; End Of The Cooking Process - Silvercrest SHF 1400 A1 Instrucciones De Servicio

9.6 Interrupting the
cooking process
NOTE: to stop the cooking process com-
pletely, e.g. in order to return to the basic
setting, press and hold the Start/Stop
button 20.
You can interrupt the cooking process at any
time, e.g. to check the degree of browning.
• Briefly press the Start/Stop
ton to interrupt the cooking process.
- The button symbol
- The heating symbol
longer displayed.
- A signal sounds.
- Temperature and cooking time are
displayed alternately for approx.
1 minute.
- When the frying basket 5 is removed,
the fan stops until the frying basket is
pushed back in.
• Press the Start/Stop button
to continue the cooking process.
68 GB
20 but-
20 flashes.
24 is no
20 again
9.7 End of the cooking
process
• An audio signal sounds when the pro-
gram has finished. The fan continues to
run for approx 1 minute before the de-
vice is switched to standby.
• You need a heat-resistant surface and a
plate or bowl (pre-heated if necessary).
• To disconnect the device from the mains
pull the mains plug 11 after use.
1. Use the handle 9 to pull the pan 10 out
of the housing 1. Place the pan 10 on
the heat-resistant surface.
2. Figure A: slide the safety catch 7 in
the direction of the arrow.
3. Press the button for unlocking the frying
basket 8 and lift the frying basket 5 up-
wards out of the pan 10.
4. Place the frying basket 5 on the heat-re-
sistant surface. Place the food on the
prepared plate / in the prepared bowl.
5. Allow the device and accessories to
cool down before cleaning them.
NOTE: if, for example, the degree of
browning does not yet meet your require-
ments, you can adapt the cooking process
manually (see "Manual settings" on
page 67). Slide the pan 10 with the filled
frying basket 5 back into the housing 1 and
restart the cooking process. Check the level
of browning after a few minutes (see "Inter-
rupting the cooking process" on page 68).