Vertex Life Paris Manual De Instrucciones página 22

INSTALLATION
Before installing, it is necessary to respect the following indications.
Choose a definitive place to place the stove and then:
• Plan the connection to the flue for the evacuation of the fumes.
• Support the stove on the floor in a favorable position for the connection of the smoke duct and close
to the "air for combustion".
• The appliance must be installed on a load-bearing floor adequate.
• If the existing construction does not satisfy this requirement, appropriate measures must be taken
(e.g., distribution plate of load).
• It is necessary to protect from heat all structures that can catch fire if exposed to excessive heat.
Floors made of wood or flammable material must be protected with non-combustible material (for
example: a 4 mm sheet or glass glass-ceramic).
• The installation the apparatus should to guarantee a easy access for the cleaning the own self
apparatus, the ducts from gases exhaust and flue pipe.
• The appliance is not suitable for installation in duct shared.
• During its operation, the stove removes a quantity of air from the environment where it is located,
therefore, it is necessary that the room where it is located has an air recirculation system.
• The pipes to be used for the smoke outlet must be specific pipes for solid fuel stoves: painted steel or
stainless steel.
• It is always advisable to respect the minimum distances and, if necessary, also install heat-resistant,
fire-retardant insulating panels (rock wool, cellular cement, etc.).
• When the stove is turned on, it can create depression in the room where it is installed; therefore, no
other appliances with naked flame should coexist in the room, except type c boilers (watertight).
• Check the presence of combustion air. It must come from a free space (not spaces where there are
extraction fans or space without ventilation) or from the Exterior.
• Do not install the stove in bedrooms or living rooms. bath.
• It should not be placed near curtains, armchairs, furniture or other flammable materials.
• It must not be installed in explosive atmospheres or environments that may be potentially explosive
due to the presence of machinery, materials or dust that may cause gas emissions or be easily ignited
by sparks. Before installing the corner pellet stove, check that all the finishes or possible beams made
of combustible material are located at a suitable distance and outside the radiation zone of said
chimney; Likewise, it must be considered that in order not to prejudice the correct operation of the
appliance, it is essential to create a recirculation of the air in its inside.
Page 6of 17