Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Fans (only for models with fan)
The fans are connected to a circuit controlled by a switch. Its consumption is equivalent
to that of a 20 W light bulb. In position 0 the fan is off. In position 1 the fan is on.
MAINTENANCE
Before carrying out any maintenance operation on the stove, take the following precautions:
Make sure that all parts of the stove are cold.
•
•
Make sure the ashes are completely off.
•
Disconnect the plug from the socket, to avoid contacts accidental.
After the maintenance phase, check that everything is in order as before the intervention (burner
•
positioned correctly).
ATTENTION! Please carefully follow the cleaning instructions
below. Failure to comply may cause problems in the operation of
the stove.
Daily cleaning
1. Combustion chamber cleaning:
Empty the ash box: vacuum it or throw the ash in the basket of the trash.
−
Vacuum the combustion chamber: Take care that there are no burning embers yet. If so, your
−
ash vacuum will will burn
Remove the ash that is located inside the stove and in the door.
−
Clean the glass with a damp cloth. If the operation is carried out with the stove hot, it could
−
explode. glass.
2. glass cleaning
The stove has a self cleaning glass system. While the stove is working, a layer of air moves
−
along the surface of the stove, keeping ashes and dirt away. However, over the hours a grayish
patina will form that must be cleaned when the stove is turned off. That the glass gets dirty
also depends on the quality and quantity of pellet used.
The cleaning of the glass must be carried out with the stove cold and the products recommended
−
and tested by our company.
When carrying out this operation, always check that the gray gasket around the glass is in good
−
condition. Failure to check the state of this joint can compromise the operation of the stove.
However, low-quality pellets can dirty the glass.
Page 12of 17
Publicidad
Tabla de contenido
