Frequent Problems - Vertex Life Paris Manual De Instrucciones

FREQUENT PROBLEMS

TROUBLE CAUSE
Wood green or too much wet
The logs They are too fat
The fire turns on
Wood from bad quality
wrong or no I know
maintains
primary air insufficient
Shot is insufficient
Excess from air primary
The fire I know
accelerate
Shot is excessive
the conduit from smoke is cold
The room is on depression
Smoke emission to
turn on or during the
Shot is insufficient
combustion
Wind enters inside the conduit
Wood from bad quality
Heating insufficient
Bad mix from air hot from
convection.
Shot is insufficient.
The glass is dirty
Absence from admission from
quickly
air the Exterior.
Wood green or too much wet.
Wear Quick from the Ventilation
elements from steel. apparatus.
Utilization abusive of liquid
The meeting from the
abrasive when I know clean
door I know takes off
the crystal.
Condensation inside Combustion from wood wet to
the apparatus fire slow .
Absence from Exit
Lack
from air hot of the
defective.
insert
SOLUTION
Use dry wood and what is been stored in a closed place and ventilated.
For the switched on, use paper, ignition pads and little wood dry.
For the maintenance from fire, use logs matches.
Use wood dry of oak, ash, maple, birch, elm, beech, etc. They have
high calorific value and produce good embers.
To open completely register from admission from air primary.
check what the conduit no East blocked, make a chimney sweep Yes
is necessary.
Insufficient tube length. Expand tube.
Close partial or completely the registration admission from air primary
.
check what the clapper from threw no I know is left open.
Install a moderator from threw.
Reheat the conduit burning a Torch from paper inside the home.
Inside from a bedroom equipped with a MCV (mechanical ventilation),
ajar a window what from toward the outside.
check what the conduit no East blocked, make a chimney sweep Yes
is necessary.
Insufficient tube length. Expand tube.
Install a windproof finish .
check that the length of the duct exceeds the ridge of the roof.
Use wood dry of oak, ash, maple, birch, elm, beech, etc. They have
high calorific value and produce good embers.
Check the circuit from convection (rack from entry, from diffusion,
conduit d air).
check what the conduit no East blocked, make a chimney sweep Yes
is necessary.
Insufficient tube length. Expand tube.
Install a rack from admission from air (20x20 cm by example) near
from the chimney.
Use dry wood and what is been stored in a closed place and ventilated.
check the circulation from air, recovering the heat the apparatus
increasing the openings and the grids from ventilation.
insufficient the
check what the system from aeration no East blocked by the grids
closed (use grids no adjustable).
Empty every day the ashtray.
Use cleaning fluids from way what no I know strain below of the glass
or clean up with a product foam.
Use dry wood and what is been stored in a closed place and ventilated
(careful, the wood newly cut contains more or less 5L from Water for
10 kg).
check what is stream. Always there are what connect the wire to a
from electricity. Fan Plug integrated.
No I know can do fire without stream or well use other feeding. Change
the element defective.
Page 14of 17