1/2" Flat Head Screw - Sauder Whisker Manual Del Usuario

STEP 7
Flip the UPRIGHT (G) over.
å
Fasten an EXTENSION RAIL (1) to the UPRIGHT (G). Use three 1/2" FLAT HEAD SCREWS (16).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1st hole shown in the diagram.
å
Then, slide the inner cartridge of the EXTENSION RAIL in to find the other holes that line up
with the holes in the UPRIGHT. Turn a SCREW into each hole.
Open end
Page 12

1/2" FLAT HEAD SCREW

(3 used in this step)
1
st
1
G
429610
1
st
1
16
Open end
whiskersupport.com