Gold 5/16" Flat Head Screw - Sauder 414141 Instrucciones De Montaje

6 6
Open end
Separate the EXTENSION SLIDES (Z) from the EXTENSION RAILS (Y) as shown in the upper diagram. Be prepared, the parts are
greasy.
Fasten an EXTENSION RAIL (Y) to the RIGHT END (A) and UPRIGHT (C). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END and UPRIGHT. Turn a SCREW
into this hole.
Page 10
Z
Push the black lever in and pull the SLIDE from the RAIL.
Edge with CAM DOWELS
C
Y
www.sauder.com/services
Y
Y
A

GOLD 5/16" FLAT HEAD SCREW

(4 used in this step)
Open end
3S
414141