ELICA KIT0179547 Guía De Instalación, Uso Y Mantenimiento página 11

3 Slide the mounting plate of the blower motor assembly,
from the front of the shell, gently over the mounting plate
support.
4 Push the right end of the motor mounting plate up and
snap it into the spring tab.
NOTE: The spring tab should be outside the slot in the
mounting plate.
5 Place nuts over the top of the shell on the right slots and
align mounting holes in motor mounting plate (A) with
motor mounting clip nuts and install 4 - 6 x 16 mm screws
with clip nuts (B).
A
C
B
A
A. Screw with lock washer
B. Mounting hole in motor mounting plate
C. Clip nut
6 Slide the mounting plate support (A) into the shell over the
side supports.
A
7 Replace the mounting plate support to the side supports
and fix with the previously removed 4 screws and the
additional 5 - 4.2 x 8 mm screws contained on the
hardware bag.
B
8 Attach power cord connector from the range hood to
connector on wiring box.
A
B
A. Wiring box connector
B. Power supply connector from range hood
B
11