ELICA KIT0179547 Guía De Instalación, Uso Y Mantenimiento página 8

6 Slide out the left mounting plate from under the motor
mounting bracket.
A. Motor mounting plate
B. Motor mounting bracket
A. Motor mounting plate
B. Motor mounting bracket
7 Remove the range hood internal blower motor.
8 Replace the grease filters on the hood.
Prepare for Mounting the External Blower System
The External Blower System must be fastened to a secure
structure of the wall or new or existing frame construction.
The 7 holes on either the inlet (bottom) side or the outlet
(top) side of the blower must be used to mount the external
blower system to the structure.
NOTE: The mounting hole locations must span the studs.
Additional stud framing may be required. Plywood may be
used to span open areas between ceiling joists or roof rafters
to aid installation. This structure must be strong enough to
support the weight of the external blower system (83 lb [37.5
kg] min).
8
Prepare the External Blower System
A
I WARNING
Excessive Weight Hazard
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
1
2 Using two or more people, move the external blower motor
3 Remove the 20 screws from the front cover of the external
4 Remove the front cover of the external blower motor
5 Disconnect the motor electrical plug from the blower
6 Remove the screws that secure the blower motor assembly
A
7 Pull the spring clip to release the blower motor assembly.
Prepare the External Blower System
I WARNING
Excessive Weight Hazard
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
1
2 Determine which venting method to use: roof or wall
3 Using two or more people, move the in-line blower motor
4 Remove the 10 - 3.1 x 15 mm screws from the cover of the
Disconnect power.
system to the mounting location.
blower motor housing and set them aside.
housing and set it aside.
NOTE: To make the external blower motor housing easier
to mount, the blower motor assembly can be removed.
motor assembly.
to the external blower housing and set them aside.
Remove the blower motor assembly from the housing and
place it on a covered surface.
A
C
A. Front cover
B. Blower mounting screws
Disconnect power.
exhaust.
system to the mounting location.
shell and save them for later. Remove the front cover of the
shell and set it aside.
A
B
A
B
C. Motor electrical plug
A. 3.1 x 15 mm screws
B. Cover of the shell