Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To work with this microscope, sharp and pointed aids are being used.
Please take care that this microscope and its accessories are stored at a
place out of reach of children. Let children only work with this microscope
Keep packing material (plastic bags etc.) away from children!
1. Scope of delivery
Stereo microscope (A), interchangeable objectives (B): 1.0x (Art. No. 5802520) or
0.5x/1.0x/2.0x (Art. No. 5802530), 1 pair of WF10x eyepieces (C), 1 pair of rubber
eyecups (D), power cable (E), spare fuse (F), dust cover (G), Instruction manual (H)
Also required (not included):
small Philipps screwdriver, small flathead screwdriver
2. Parts overview
B
Eyepieces
Diopter adjustment ring
C
Objective
with clamping screw (3a)
Front microscope arm
Microscope pole
F
Rear microscope arm
Locking ring
Microscope base
3. Finding the right location for observation
Dry and dust free, room temperature between -5 and +40°C.
Position your device so that it can be disconnected from the power supply at any
time. The wall socket should always be located near the device and be easily ac-
cessible, since the plug on the power cord serves as a disconnecting device for
the power supply.
4. Assembly
1. Place the base (8) on a stable surface.
2. Attach the rear microscope arm (6) to the pole of the microscope base.
3. Use the locking ring (7) to secure the microscope arm.
4. Connect the front part of the microscope arm (4) to the rear arm. Insert the con-
necting screw (9) through the hole in the rear microscope arm. Take care that
the flattened edge shows backwards. Now attach the the front microscope arm
to the screw. Tighten the lock nut (10) with the lever until the front microscope
arm does not tilt down.
8
CAUTION!
under an adult's supervision!
J
Connecting screw
Lock nut
Focusing wheel
Illumination
Power socket
Fuse holder
On/Off switch
Rubber eyecup
replacement fuse (F2AL250V)
Publicidad
Tabla de contenido
