General Operation - GYS SMART WIRELESS MODULE Manual De Instrucciones

Operating manual
EQUIPMENT DESCRIPTION (FIG 1)
The Smart Wireless Module (SWM) is an accessory that allows the user to operate a GYS device fitted with an SMC
port via a wireless Bluetooth communication.
1 SMC connector
2 SMC cable
3 Indicator light
4 Pairing button
This equipment is delivered with a DB9 cable to connect it to a Gys battery charger, delivering a 24 V and another 5 V
voltage. The equipment must not be connected to any other voltage source, otherwise there is a risk of malfunction,
damage to the equipment and risk to the user.
SETTING UP THE EQUIPMENT
1. Connect the SWM to the GYS device being operated (e.g. Gysflash CNT) using the SMC cable.
GYSFLASH CNT
2. Switch on both the controlled device and the computer.
3. Turn on the computer's bluetooth feature.
4. Open the dedicated SWM software (GYS' CNT Datalog or custom software).
5. Then, use the indicator light to check the machine's status:
Indicator light status
Green (fixed)
Green (flashing)
Orange (flashing)
Orange (fixed)
Swtiched off
6. The SWM will automatically connect to the last device to which it was connected. Press the push button (4) to connect
it to a new device. This will make the SWM return to pairing standby and it can be connected to a new device.

GENERAL OPERATION

The SWM enables the user to exchange data with a GYS product using a Bluetooth connection.
The SWM is accepted as a Low Energy Bluetooth device.
A compatible Low Energy Bluetooth device (LEB), or one with a suitable dongle, is required to operate the SWM. The
user can also develop their own application using the LEB device's API (application programming interface) provided
for the user's particular operating system (Android, IOS, Linux or Windows).
Using this API, the user is able to scan nearby LEB devices, connect to the SWM and transmit information to their
specific software.
10
Translation of the original
instructions
SMC cord
SWM
Meaning
Ready for communication (CNT charger connected and Bluetooth pairing OK).
CNT charger connected but no connected Bluetooth device.
Initialising or updating phase. Usually stops after five seconds.
Internal error. Disconnect and reconnect the SWM.
No power supply. Check that the SMC cable is connected correctly and that
the CNT charger is switched on.
SMART WIRELESS MODULE
COMPUTER