MSW -MS-65 Manual De Instrucciones página 28

a) Fit the appropriate drill/bit sharpening attachment (D) on the device.
b) Remove the clamp from the clamp mounting and insert the drill bit to be
sharpened (see figure 1a). Pull the clamp so that the drill bit has some free
play.
c) Insert the clamp with the drill bit in the clamp mounting pocket, using the
special groove for this purpose (figure 1b).
d) Move the drill bit forwards, so that it remains in the guide wedge and touches
the limiter (figure 1c).
e) Rotate the drill until the wedge-shaped guide covers it completely (figure 1c),
i.e. all 4 corners of the drill should touch the walls of the wedge-shaped guide.
f) Make sure that the drill and the clamp were fully inserted in the groove. Then,
screw in the clamping knob (figure 1d).
g) Lift the guide wedge and remove the clamp and the drill bit.
h) Turn the guide from one side to other, blocking it and pressing on it slightly
with finger (figure 1f).
i) Switch the device with the ON/OFF button (A).