MSW -MS-65 Manual De Instrucciones página 30

a) Fit the appropriate knife/scissor sharpening attachment (C) on the device.
b) Switch the device with the ON/OFF button (A).
c) Spread the scissor blades as far as possible (scissors fully open).
d) Insert the first blade of the scissors into the groove on the attachment (figure
2d) – the axis of the scissors and keep the other blade on the right side of the
attachment.
e) Move the blade of the scissors along the stone from the axis to the tip while
maintaining a constant, light pressure on the blade – do not press too hard!
(figure 2e).
f) Remove the scissors and turn them over to sharpen the second blade (figure
2f) – hold the axis of the scissors and their other blade on the right side of the
attachment.
g) Repeat the sharpening of each blades until even, sharp cutting edge is
obtained.
h) After completing the sharpening and if the device is no longer used switch it
off with the ON/OFF button. Wait until the whetstone stops before removing
the attachment.
3.3.3 Sharpening chisels/planes