Installing Stainless Steel Handle - Teka RVF 20110 GBK Manual Del Usuario

Damages due to power surges are not considered a manufacturer covered defect and will void your product
warranty.
Installing the stainless steel handle
This wine chiller includes a stainless steel handle. To install the handle please follow the below instructions:
1. Pull away the door gasket in the area where the handle is to be installed on the left side as shown below in
Illustration # 1. The gasket is easily displaced by hand, no tools are necessary.
2. Align the handle with the screws installed. Tighten the screws using a Phillips head screwdriver until the
handle sets both flush and secured tightly against the door frame. (DO NOT over tighten as this will cause
damage to the handle assembly).
3. Replace the door gasket to its original position.
4.
If you choose not to use the handle supplied, simply follow step 1 to access the installation screws and remove
them and then place the two decorative plugs into the two holes separately. Continue on to step 3 to replace
the door gasket to its original position.
1.
2.
Illustration # 1
Gasket
Phillips Head Screw
Illustration # 2
3. Phillips Head Screw Driver
4. Handle
4