Polaris MAXX Manual Del Propietário página 6

STEP 5. Connect the Cleaner
1. Ensure that the flow regulator valve (FRV) (e) is attached to the leader hose (c). The leader hose is
the hose section with the foam float pre-attached. (Figure 5).
2. Submerge the hose and flood with water (no bubbles visible).
3. Submerge the cleaner and flood with water (no bubbles visible).
4. Connect the hose to the cleaner head by pushing the flow regulator valve onto the cleaner.
5. Allow the cleaner to sink to the bottom of the pool.
Figure 5. Connect Hose and Submerge Cleaner
STEP 6. Test for Proper Flow
To avoid serious injury, make sure to turn off the suction pump that is responsible for the pool cleaner
operation. Do not expose your hair, loose clothing, jewelry, etc. to the open end of the hose.
The flow regulator valve is designed to consistently limit high flow of water through the cleaner. When
flow is correct, the cleaner components are less susceptible to damage and the life of the cleaner can be
extended. Wheel rotation speed is a good indicator of how much water is flowing through the cleaner. By
checking for proper wheel rotation timing, you can verify the cleaner is operating at maximum efficiency.
6
c
WARNING