Installation In Harness Mode - Britax GROW WITH YOU CLICKTIGHT Guia Del Usuario

Britax Child Safety, Inc.

Installation in Harness Mode

Lap-Shoulder Belt with CLICKTIGHT (Preferred Method)
Before you begin:
• Check that your vehicle has a top tether anchor.
• Britax recommends that the top tether be used at all times
when installing the child seat. Using the top tether will improve
the stability of your child seat and reduce the risk of injury.
Check your vehicle owner's manual for tether anchor locations.
• Loosen the tether and place it over the child seat back to keep
it from becoming pinned between the child seat and vehicle
seat during installation.
• Adjust the child seat to desired position and place forward
facing on the vehicle seat.
1. Release the buckle and
open the CLICKTIGHT.
a. Locate the two slots
in the CLICKTIGHT
cover.
b. Squeeze the
CLICKTIGHT release
levers.
2. Pull the vehicle belt out
and route along the green
belt path. Verify that the
belt is not twisted and then
buckle.
3. Remove slack from the lap
part (A), then shoulder part
(B) of the vehicle belt.
IMPORTANT:
the belt may prevent the
CLICKTIGHT from properly
securing.
4. Close the CLICKTIGHT.
A click helps confirm the
CLICKTIGHT is secure.
NOTE: The child seat is
secure when it cannot be
moved front-to-back or
side-to-side more than
1 in. (2.5 cm) at the belt
path. If the child seat
is not secure, repeat
the installation or use a
different seating location.
10
Overtightening
Table of Contents