Installation; Rear-Facing Installation Harness Mode - Britax ONE4LIFE CLICKTIGHT Guia Del Usuario

Installation

REAR-Facing Installation Harness Mode

Britax strongly recommends that children should ride REAR-
facing until they exceed the weight or height limits specified.
Use REAR-facing only:
• with harness straps in closest
position below the child's
shoulders, and
• with children weighing 5 - 50
lb (2.3 - 22.7 kg), and
• when the top of child's head
is at least 1 in (2.5 cm) below
the top edge of headrest.
For models with anti-rebound
bar:
Follow the instructions on page
17 to attach the anti-rebound
bar to the child restraint before
installing.
Installation with Vehicle Lap-Shoulder Belt (Preferred
Method)
1. Place child restraint
REAR-facing on the
vehicle seat so that the
car seat base is flat on
the vehicle seat and is
parallel to vehicle seat.
2. Recline child restraint to
the appropriate position.
Refer to page 15 to
determine appropriate
recline position.
3. Ensure that no more than
3 in (7.6 cm) of base hangs
over front edge of vehicle
seat.
18
3 in 3 in