Stopping The Engine; Alternating Current (Ac) Connection - CAMPAGNOLA ENERGY4 Manual De Uso Y Mantenimiento

WARNING!
The choke is not required to start a warm engine. Push the choke knob in to the position "OPEN".
4- Slowly pull the recoil starter handle
WARNING!
Grasp the carrying handle
5- After the engine starts, warm up the engine until the engine does not stop when the choke lever is turnedto the
"OPEN" position.
6.2

Stopping the engine

WARNING!
- Before stopping the Generator engine, turn off all connected electrical devices.
- Turn the generator switch to the "OFF" position (see par. 4.7).
- Turn the fuel tap to the "0" CLOSE position.
The ignition circuit is off, the fuel is closed.
- After the engine has completely cooled down, turn the air vent knob to "OFF" - 1.
6.3

Alternating Current (AC) connection

WARNING!
- Make sure all electrical devices are turned off before connecting them to the Generator.
- Be sure ali electric devices including the Iines and plug connections are in good condition before connection
to the generator.
- Be sure the total load is within generator rated output.
- Be sure the receptacle load current is within receptacle rated current.
NOTE: if the Generator is connected to the 220 V AC mains, the Generator must also be connected to earth via
the Earth terminal (see par. 4.11).
Page 34
until it engages, then pull it quickly to start the engine.
firmly to prevent the generator from falling over when pulling the recoil starter.
Use and maintenance manual – Translation of
original Instruction Rev.: 00, Date 01/03/2022