Placing Vermiculite Stones Into The Appliance - Dovre SAGA 101 Instrucciones De Instalacion Y Uso

passing the side glass panes ensures that a cosy
glow remains visible and that the side glass panes do
not turn black completely.
Front glass
Dirt clings less easily to well-cleaned glass (front
glass in the door). Proceed as follows:
1. Remove dust and loose soot with a dry cloth.
2. Clean the glass with stove glass cleaner:
a. Apply stove glass cleaner to a kitchen
sponge, rub down the entire glass surface
and give the cleaning agent time to react.
b. Remove the dirt with a moist cloth or kitchen
tissue.
3. Clean the glass again with a normal glass
cleaning product.
4. Rub the glass clean with a dry cloth or kitchen
tissue.
Do not use abrasive or aggressive products to
clean the glass.
Wear household gloves to protect your hands.
If the glass in the appliance is broken or
cracked, it must be replaced before the stove
is used again.
Ensure that no stove glass cleaner runs
between the glass and the cast-iron door.
Stove maintenance
Lubrication
Although cast-iron is slightly self-lubricating, you will
still need to lubricate moving parts frequently.
Lubricate the moving parts (such as guide sys-
tems, hinge pins, latches and air slides) with heat-
resistant grease that is available in the specialist
trade.
Touching up damaged paint
Small areas of damaged paint finish can be touched
up with a spray can of special heat-resistant paint,
available from your supplier.
Ensure that the stove is not overburdened. If it
does become overburdened then the surface
D OVRE
12
gets very hot, possibly resulting in lasting
damage to the enamel.
Checking the seal
Check whether the door sealing rope is still in
good condition and works well. The sealing rope
is subject to wear and will need to be replaced
over time.
Check the appliance for air leaks. Close any
chinks with stove sealant.
Allow the sealant to harden fully before
lighting the appliance, as any moisture in the
sealant will form bubbles, resulting in a new
air leak.
Placing vermiculite
stones into the
appliance
The stones can be replaced if they are broken.
The steps for replacement are provided below.
If you replace a complete set of vermiculite stones,
begin with the back wall (see drawing 09-20023-
005). The stone has no. 03.77695.000. This number
is on the back and is no longer visible once the stone
has been installed in the appliance.
Next, place the two sides (see drawing 09-20023-
006). The sides have numbers 03.77698.000
and 03.77696.00 for the SAGA 101, and
Subject to change because of technical improvements
09-20023-005