Toro HoverPro 450 Manual Del Operador página 9

Assembling the Upper and Lower
Handlebars
1. Align the holes on the upper handlebar with the
holes in the lower handlebar
1. Lower handlebar
2. Knob
3. Washer (6 mm)
2. Assemble the upper handlebar to the lower
handlebar wit the 2 U-bolts, 2 washer (6 mm),
and 2 knobs.
Assembling the Cable to the
Operator-Presence Bail
1. Insert the fitting at the end of the cable sheath
into the upper socket of the handlebar fitting
(Figure 9).
1. Handlebar fitting
2. Squeeze the leg of the operator-presence bail
until you can remove it from the upper handlebar,
(Figure 8).
Figure 8
4. Upper handlebar
5. U-bolt
Figure 9
2. Fitting (cable sheath)
and remove the bail from the machine
10).
g364684
3. Insert the cable fitting through the hole in the
bracket of the operator-presence bail as shown
in Figure
1. Bracket
(operator-presence bail)
4. Insert the end of the operator-presence bail into
g367356
the handlebar, squeeze the other leg of bail
slightly, and insert the bail into the handlebar
(Figure 13).
7
Figure 10
11.
Figure 11
2. Cable fitting
(Figure
g367353
g367355