I - Troubleshooting; Possible Problems - Campingaz 360 GRILL CV Instrucciones De Empleo

I - TROUBLESHOOTING

In case of burn back (ignition under the burner cap) switch the product off, allow it to cool down (approximately five
minutes), then reignite the appliance. If the problem of burn back persists, then please contact your local Campingaz
representative.

Possible problems

The burner does not light up
The burner does not burn smoothly or goes out
Unstable blowing flames
Large plume of flame on the burner surface
Flame at the injector
Burning leak around a union
GB
Insufficient heat
Burning leak behind the adjustment knob
Probable causes / Corrective action
• Poor gas supply
• Regulator not operating properly
• Pipe, valve, venturi tube or burner holes obstructed. Clean the venturi.
• Check that gas is present
• Check the pipe connection
• Contact your servicing agent.
• New cylinder may contain air. Allow the appliance to operate and the
fault will clear itself
• Residual water, after the washing of the burner or filling/emptying of the
bowl. Allow the appliance to operate and the fault will clear itself.
• Contact your servicing agent.
• The venturi is obstructed (possibly cobwebs)
• Contact your servicing agent.
• The cylinder is almost empty
• Change the cylinder and the fault will clear itself
• Contact your servicing agent.
• Shut off the gas supply immediately
• Leaking union: tighten nuts or change pipe
• Contact your servicing agent.
• Injector or venturi tube obstructed. Clean the venturi.
• Contact your servicing agent.
• Defective valve
• Shut down the stove
• Contact your servicing agent.
8
®