X-lander X-PULSE Manual Del Usuario página 8

1 u n F o l D i n g t h E F R a M E
Unclip the linking interlock (a). Unfold the pram by lifting its handle up until the locks (b)
are engaged.
gears have been locked.
2 F o l D i n g t h E F R a M E
Detach the carrycot, seat unit or car seat from the frame. Pull the grips on the handle
upwards (a). Fold the frame holding the handle as shown in the picture (b).
3 a s s E M B lY a n D D i s a s s E M B lY o F R E a R W h E E l s
To assembly or disassembly the wheel, push rubber button, which is in the middle of the wheel.
4 M o u n t i n g o F t h E F R o n t W h E E l
In order to mount the wheel, slide it onto the axle until the lock is engaged.
5 D i s M o u n t i n g o F F R o n t W h E E l
In order to take the wheel off, push the button shown on the figure, and pull the wheel
off the axis.
6 W h E E l B lo c k a D E
The stroller is provided with swiveling front wheels. A special button blocks the wheel
swiveling movement. After the button has been pressed, the wheels are blocked stra-
ight. To release the blockade, press the lever.
7 h a n D l E l E n g t h R E g u l at i o n
Press the button in the middle of the handle and adjust its height by pulling it towards
you to lengthen it or pushing it away from you to shorten it.
8 B R a k E
To apply the brake: push the pedal down with your foot (a). To release the brake push the
pedal down from the other side (b).
9 s h o P P i n g B a s k E t i n s ta l l at i o n
Fasten the snap fasteners and attach the basket to the chassis as shown in the pictures.
10 i n s ta l l i n g s E at u n i t o n t h E F R a M E
Slide the catches of the stroller seat unit into mounting seats in the frame, until locks are
engaged. The seat unit can be mounted facing front or rear.
11 D i s M o u n t i n g s E at u n i t F R o M t h E F R a M E
Push the buttons unlocking catches of seat unit in (a), then pull it out from mounting seats (b).
12 M o u n t i n g / R E M ov i n g t h E s t R o l l E R h o o D
In order to mount the hood pass the plastic ends of the straps through the upper openings
at the top of the backrest (a,b). Then press the tabs of the hood on the stroller seat tube (c).
To remove the hood remove the holding clips from the tube and remove the plastic ends of
the straps from the openings (d).
13 B ac k R E s t a D J u s t M E n t
Pick up the tie and put up the backrest in required position.
14 F o ot R E s t a D J u s t M E n t
Press the buttons on both sides of footrest and adjust it to the required position.
15 i n c R E a s i n g t h E h o o D i n c l i n at i o n a n g l E
The hood may be expanded by an additional part. In order to do this, undo the zipper
between the upper and lower part of the hood.
16 i n s ta l l i n g o F B u M P E R B a R
Push in the ends of the bumper bar into mounting holes, until locks are snapped.
6
17 ta k i n g t h E B u M P E R B a R o F F
WaRning: Prior to assembling the baby carriage make sure that folding