X-lander X-PULSE Manual Del Usuario página 9

Push in the buttons of the bumper bar locks and slide its end out of the mounting holes.
The bumper bar may be tilted, when undone only from single side.
a D J u s t i n g o F h a R n E s s
18
Use the regulation underneath the shoulder pads.
R E g u l at i o n o F t h E h E i g h t o F t h E s a F E t Y h a R n E s s
19
The height of the safety harness can be adjusted depending on the age of the child.
Position 1 - When the child starts to sit unaided (around 6 months)
Position 2 and 3 - When the shoulders of the child will be at the middle or high holes level.
at tac h i n g t h E c ov E R
20
To attach the foot cover put it under the bumper bar and attach to Velcro (a) and snap (b).
B u c k l E
21
To unfasten the buckle, press the buttons and pull the fastening part out of the casing.
To fasten the buckle, insert the fastening part into the casing until it has engaged.
M o u n t i n g t h E c a R s E at
22
Special adapters are needed in order to mount the baby car seat. Place the adapters in
mounting seats of the frame and attach the car seat by catching it on the adapters.
Attention: Ensure proper fitting of the armchair before using it.
23 R E M ov i n g t h E c a R s E at
In order to take the car seat off, push in the unlocking pushbuttons on both its sides,
while simultaneously pulling it out of mounting seats. Remove adapters by pushing in the
unlocking pushbutton.
24 M o u n t i n g o F c a R R Yc ot
Special adapters are needed in order to mount the carrycot. Place the adapters in mo-
unting carrycot of the frame and attach the carrycot by catching it on the adapters.
25 D i s M o u n t i n g o F c a R R Yc ot
To take the carrycot off, push in the buttons unlocking the catches (a) and pull it out
from mounting seats (b). Remove adapters by pushing in the unlocking pushbutton.
26 M o s Q u i to n E t
The mosquito net is in the pocket under the footrest (a). Place it over the footrest and
the hood (b) and then fasten the straps round the frame bars as shown in Figure (c)
27 l E D l i g h t s
The stroller frame features LED lights. The ON button is located on the stroller frame as
shown in the picture below. The batteries are located on the bottom of the footrest. In
order to install the batteries LR 44, unscrew the screw shown in the picture and take off
the casing.
28 at tac h i n g X - B ag n u R s E R Y B ag a n D X - M u g h o l D E R
X-Mug and X-Bag nursery bag can be attached to the frame using the holders shown in
the picture.
!
Wa R n i n g s a n D P o i n t o F at t E n t i o n
Keep these instructions for future reference.
Having conducted required tests Deltim declares that the stroller complies with all the
requirements of PN-EN1888:2012 standard. ATTENTION: Do not use any other additional
accessories not listed by the manufacturer.
7