Cleaning, Care & Maintenance; Troubleshooting - Polar Refrigeration G604 Manual De Instrucciones

UK
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.
• A POLAR agent or qualified technician must carry out repairs if required.
Cleaning the Condenser Filter
• The condenser is part of the refrigeration
system. The condenser filter requires monthly
cleaning.
• Always disconnect power supply before carrying
out Routine Maintenance.
• Failure to clean the condenser filter will reduce
the performance and life of your Polar unit and
may invalidate your warranty.
• These models have a removable filter which can
be cleaned with a vacuum cleaner.

Troubleshooting

If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline or your POLAR dealer.
Fault
The appliance is not
working
8
G604-G607_ML_A5_v10_20181010.indb 8
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Solution
Check the unit is plugged in correctly and
switched on
Call POLAR agent or qualified Technician
Replace the fuse
Check power supply
Call POLAR agent or qualified Technician
2018/10/10 16:25