Cleaning, Care & Maintenance - Polar Refrigeration CE210 Manual De Instrucciones

Installation
Note: If the unit has not been stored or moved in an upright position, let it stand upright for approximately
12 hours before operation. If in doubt allow to stand.
1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings
are thoroughly removed from all surfaces.
2. Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for ventilation.
Increase this distance if the obstacle is a heat source.
3. Set the brakes on the castors to keep the appliance in position (DN495/DN496) OR Level the
appliance by adjusting the screw feet (CE210/CE211/CE212).
Note: Before using the appliance for the first time, clean the baskets and interior with soapy water.
Operation
Storing Food
To get the best results from your POLAR appliance, follow these instructions:
Only store foodstuffs in the appliance when it has reached the correct operating temperature.
Do not place uncovered hot food or liquid inside the appliance.
Wrap or cover food where possible.
Avoid opening the doors for prolonged periods of time.
Turn On
1. Close the lid of the appliance.
2. Turn on the appliance.
3. Set the thermostat to the desired
temperature.
Defrost
Polar recommend defrosting the appliance when any frost build up inside the freezer reaches 5mm thick.
To do this switch the freezer off at the power supply.
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
Clean the interior of the appliance as often as possible.
Do not use abrasive cleaning agents. These can leave harmful residues.
Clean the door seal with water only.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
Take care when cleaning the rear of the appliance. Sharp edges can cut.
A POLAR agent or qualified technician must carry out repairs, if required.
Telephone Helpline: 0845 146 2887 (United Kingdom)