Teka RVI 460 Manual Del Usuario página 34

OPERATING YOUR WINE COOLER AND SETTING THE TEMPERATURE
Ø Control System Instruction
•
" DISPLAY "
To shows the set temperature.
•
" " Button
Used to rise the temperature 1 ℃.
•
" " Button
Used to down the temperature 1 ℃.
•
" "Button
To control the inner light, turn on/off.
(Press this button, the light is on, and the light is not controlled by door. Press this button again,
the light is off, and the light is controlled by door.)
NOTE: It will take 3 seconds for LED light completely went out after turning off the light.
•
" " Button
To control this appliance, turn on/off.
(Press this button, the power is on. Press this button with 3 seconds again, the power is off.)
Ø Setting The Temperature Controls
•
The temperature range 5℃～18℃.
•
The acquiescence temperature setting is 12℃.
•
When the system enters the set-up temperature. Each press once
temperature setting will increase or lower 1℃, When the temperature setting reaches the upper
limit 18℃ and lower limit 5℃, the temperature setting will not increase or lower.
•
If you want to know the actual temperature, please press
will show actual temperature. After 5 seconds, it will show the setting temperature.
Ø Internal light
• In order to reduce energy consumption, the LED light within this wine cooler will automatically
switch off when closed the door. If you would prefer the LED light to remain on continuously,
this is possible. Please press and hold the "
LP". After 4 seconds the display will revert to normal and the light will remain on until
manually switched off.
CONTROL
" button for 5 seconds, the display will show "
5
or
or for 3 seconds, display panel
button, the