How To Determine The Device Version Number In User Mode; How To Create An Admin Pin In User Mode - Kingston IronKey Keypad 200 Manual Del Usuario

Note: If the Timeout Lock feature has been set by the user in 'User Mode', the Administrator is able to
change the user setting in Admin mode. If the Administrator set the Timeout Lock feature in 'Admin
Mode', the user is disabled from making any change to the Timeout feature in User Mode.

10. How to Determine the Device Version Number in User Mode

To display the device Version Number of the KP200 do the following.
Instructions
1. Unlock the KP200 your User PIN
2. Press the KEY button three times- (triple-click)
3. Press button number 8 followed by the
number 6 button - (86)
4. Press the KEY ( ) button once and the following happens;
a. All LEDs (RED, GREEN
b. RED LED blinks indicating the integral part of the firmware revision number.
c. GREEN LED blinks indicating the fractional part.
d BLUE LED blinks indicating the last digit of the firmware revision number
e. All LEDs (RED, GREEN
f. RED, GREEN & BLUE
For example, if the revision number is '1.12.3', the
twelve (12) times and the
& Blue LEDs will blink together once and then to solid Green.

11. How to Create an Admin PIN in User Mode

If no Admin PIN exists, the user is able to create an Admin PIN by following the instructions in the table below.
The Admin PIN is a useful feature for corporate deployment, for example:
• Recovering data from a drive and configuring a new User PIN in the event an employee has forgotten their PIN
• Retrieving data from a drive if an employee leaves the company
• Setting Admin defined user policies
• The Admin PIN can be used to override all user settings
PIN requirements:
• Must be between 8-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7-8), (7-8-9-0-1-2-3-4), (8-7-6-5-4-3-2-1)
& BLUE) will flash together once.
& BLUE) become solid for 1 second.
LEDs switch to a solid Green
Blue LED will blink three (3) times. Once the sequence has ended the Red,
www.kingston.com
LED LED State
Green LED will be solid indicating successful
User PIN entry
Solid Green
Green and
is awaiting new user defined settings
Green and
LED
Red LED will blink once (1) and the
LED switches to blinking
Blue LEDs indicating the drive
Blue LEDs will continue to blink
Green LED will blink
Green
#11