Troubleshooting - ECOVACS WINBOT X Manual De Instrucciones

Malfunction Indicator
glows a solid RED
flashes RED
WINBOT
doesn't work
glows a solid RED
flashes RED
Possible Causes
Safety Pod is losing suction.
Safety Pod Jack is not properly connected
to the Safety Pod Port on WINBOT.
Safety Pod is in sleep mode.
Safety Pod is not paired with WINBOT
(WINBOT comes with a paired Safety Pod.
If Safety Pod becomes unpaired or has
been exchanged, it can be paired again).
Safety Pod's battery is low.
WINBOT is stuck or losing suction.
Edge Detection Sensors are blocked or
dirty.
WINBOT's battery is low.

6. Troubleshooting

Solutions
A. Press the Safety Pod firmly to see if
GREEN within 5 seconds.
B. Take the Safety Pod off the window and use the Finishing
Cloth to wipe it clean, then repeat Solution A.
Insert the Safety Pod Jack into the port, press it and turn
clockwise until it locks.
Power OFF Safety Pod then power it ON again.
Within 5 seconds of powering ON WINBOT, press and hold
on WINBOT and on the Safety Pod at the same time.
Pairing is complete when WINBOT beeps and
RED and GREEN.
Open the battery compartment at the bottom of Safety Pod
and change the batteries.
A. Press on the Remote Control once and then use
to move WINBOT away (at least 10 cm/4") from the problem
area and resume cleaning.
B. Press on the Remote Control once and then press
and hold it until glows a solid BLUE and
GREEN. Use to move WINBOT to a position where you
can safely reach it. Remove WINBOT from the window and
restart again.
If the problem persists, please contact customer service.
Use a clean, dry cloth to wipe Edge Detection Sensors clean
as described in Section 4.2.
If the problem persists, please contact customer service.
Plug in adapter and charge WINBOT.
glows a solid
flashes
glows a solid
25
EN