Troubleshooting - Furrion FCR10DCBTA-BL Manual De Instrucciones

Troubleshooting

If you encounter a problem with the refrigerator as below tables stated, firstly try the
suggested solutions. If problems persist, please call the service or the dealer.
Problem
Refrigerator does not
operate
Compressor turns on and off
Refrigerator compartments
are too warm
Vibrating or rattling (slight
vibration is normal)
The temperature on the
exterior of the refrigerator
is high.
Moisture collects inside the
refrigerator
Moisture forms on outside of
refrigerator
Bubbling or gurgling sounds
(like boiling water)
Popping or cracking sounds
when compressor comes on
The door cannot be closed.
13
CCD-0005596 REV: 10.12.2022
Ensure that the refrigerator is powered on correctly.
Check whether the room temperature is higher than the normal.
Check whether the door is open or is frequently opened.
Check whether the refrigerator has been recently disconnected for a
period of time.
Ensure that the temperature control is set correctly.
Check whether the door is open or is frequently opened.
Ensure that the door gasket is properly sealed.
Ensure that the warm or hot foodstuff is cooled down before storing in
the refrigerator.
Check if the refrigerator has been recently disconnected for a period of
time.
Adjust the leveling legs.
Ensure that the refrigerator is placed on a flat and solid surface.
Check if the temperature of the exterior refrigerator walls is much
higher than the room temperature 30°C.
This is normal when the surface is warm, because the compressor
works to convey the heat from the interior to the exterior.
Check whether the door is open or is frequently opened.
This is normal when in hot and humid weather.
This is the normal sound of refrigerant (used to cool refrigerator)
circulating throughout the system.
This is normal. Metal parts undergo expansion and contraction, like hot
water pipes. The sound will decrease or disappear as refrigerator runs.
Ensure the refrigerator is on a flat surface.
Check whether the gasket is dirty.
Check whether the storage drawer is out of position.
Solution