Bosch GTB18V-45 Instrucciones De Funcionamiento Y Seguridad página 10

Ocultar thumbs Ver también para GTB18V-45:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Replacing Screwdriver Bit
and Bit Holder
1. Remove the depth adjusting sleeve
(3) by grasping firmly WITH YOUR
HAND and pulling straight out. DO
NOT USE PLIERS (Fig. 5).
Fig. 5
3
2. Remove the screwdriver bit (1) by
leveraging the hole on the side of the
depth adjusting sleeve (3) against
the bit and pull the bit out (Fig. 6).
Similarly, to remove the bit holder,
leverage the hole on the side of the
depth adjusting sleeve against the
screwdriver bit and also grasp the
bit holder with fingers from the
same hand and pull both the bit and
bit holder out. If necessary, pliers
may be also used to remove either of
those items (Fig. 5).
Fig. 6
B
A
3
3. Install bit holder (if removed) and
new screwdriver bit (1).
Bit
holder
1
1
Bit
holder
Assembly
4. Then using your HAND ONLY,
reinstall depth adjusting sleeve (3).
Push depth adjusting sleeve onto
tool until it snaps into place.
Belt Clip
Your tool is equipped with a belt clip (8)
that allows you to conveniently attach
your driver to your belt (Fig. 1). This
feature will allow you to have both
hands free when climbing a ladder or
moving to another work area.
Mounting the Optional Auto-
Feed Attachment
1. Remove depth adjusting sleeve (3)
and bit holder from the tool.
2. Insert the optional special extended
screwdriver bit into the tool (Fig. 7).
3. Slide
attachment over the special
extended screwdriver bit to the stop
on the motor housing (Fig. 7).
Fig. 7
-10-
the
GMA22
auto-feed

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gma22

Tabla de contenido