Bosch GTB18V-45 Instrucciones De Funcionamiento Y Seguridad página 14

Retractable Depth Stop
The retractable depth stop allows the
tool to stop at the desired depth to help
prevent the screw head from becoming
stripped or breaking the bit tip. In
typical use, the bit tip will not be easily
visible with the depth stop in the way. In
order to help see the bit, for instance to
reverse a screw out of the material, the
depth stop can retract.
1. Line up the arrows on the depth
adjusting sleeve (3) and the gearbox
(Fig. 14).
2. Pull the depth adjusting sleeve (3)
backwards until it audibly clicks into
place on the gearbox without any
gaps (Fig. 14).
3. Once finished, pull the depth
adjusting sleeve (3) out slightly to
return to normal screwdriving mode.
Fig. 14
3
gear
gear
box
box
Operating Instructions
-14-
Tool Tips
1. Support the tool so that steady, even
pressure
screwdriving bit (1). Operate the
trigger switch (7) by depressing with
one or two fingers.
2. Lock the tool on for continuous
operation. The bit (1) will not rotate
until the clutch is engaged.
3. Place a drywall screw on the bit (1).
The magnetic bit holder will hold any
steel drywall screw without any
additional assistance.
4. Press the screw point against the
drywall with steady even pressure.
At this point, the clutch will engage,
driving the screw to the pre-set
depth. Once the screw bottoms out,
a ratcheting sound will be heard for
a second.
5. When properly set, the screw head
should pull into the drywall paper
without cracking or tearing the
paper, then release slightly below
flush with the drywall board. In this
manner, minimum work is left when
spackling screw heads and taping
the seams.
is applied to the