Tabla de contenido
Publicidad
Step 7
Step
Fasten the END MOLDINGS (O) to the ENDS (A and B).
å
Use six BLACK 9/16" LARGE HEAD SCREWS (1S) through
the ANGLE BRACKETS on the ENDS.
NOTE: There are no pre-drilled holes in the END
å
MOLDINGS. The SCREWS will tighten into the grooves.
Fasten the BOTTOM MOLDING (Q) to the BOTTOM (D)
å
and the SHELF MOLDING (P) to the SHELF (E). Tighten
four HIDDEN CAMS.
Curved edge
Page 12
P
Q
E
D
BLACK 9/16" LARGE HEAD SCREW
(6 used for the ANGLE BRACKETS)
O
B
1
2
411861
1S
O
A
These surfaces
should be even.
www.sauder.com/services
Publicidad
Tabla de contenido
