Machine Information; Technical Specifications - VONROC BJ501AC Traducción Del Manual Original

• Always wear safety goggles and hearing pro-
tection. If desired or required also use another
protection for example an apron or helmet.
• Always disconnect the plug from the socket
before carry out any work on the machine. Only
plug-in when the machine is switched off.
• Keep mains lead clear from working range
of the machine. Always lead the cable away
behind you.
• Do not stop the blade by hand after switching
off.
• The base plate must not be clamped down whi-
le the blade is extended. Lowering and raising
the blade must be a smooth operation.
• Always use the protective shields on the machi-
ne.
• Use only cutting discs whose allowable speed is
at least as high as the highest no-load speed of
the machine.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Your machine is double insulated in
accordance with EN 60745; therefore no
earthwire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is dange-
rous to insert the plug of a loose cable in the wall
outlet.
If the supply cord of this power tool is damaged,
it must be replaced by a specially prepared supply
cord available through the service organization.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
2
always unwind the reel completely.
WWW.VONROC.COM
. When using a cable reel

2. MACHINE INFORMATION

Intended use
The Biscuit Jointer is suitable for cutting grooves
for biscuit dowel joints in solid wood, plywood,
chipboard, fibre board, plexiglass and artificial
marble.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power input
No-load speed
Disc diameter
Blade bore diameter
Max. cutting depth
Fence adjustment
Weight
Lpa (sound pressure)
Lwa (sound power)
Vibration value
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned:
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level;
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work pat-
terns.
EN
BJ501AC
230-240 V
50 Hz
900 W
11000/min
Ø 100 mm
Ø 22 mm
14 mm
0 - 90°
3.2 kg
87 dB(A) K=3dB
98 dB(A) K=3dB
2.695+1.5 m/s2
7