Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm
. If you use an extension
2
cable reel, always fully unroll the cable.
2. MACHINE INFORMATION
Intended use
The machine is intended for driving in and loose-
ning screws and bolts as well as for tightening and
loosening nuts whilst adhering to the technical
data. Main purpose environment is in the automo-
tive sector, for metal construction or roofing work.
The device is not intended for drilling.
TECHNICAL SPECIFICATIONS
This manual has been drawn up for
different sets / article numbers. Check the
corresponding article number in below
specifications table for the correct
composition and contents of your set.
Batteries
Model No.
included
IW501DC
-
S_ IW501DC
CD801AA
S2_ IW501DC
2 x CD801AA
S3_ IW501DC
CD803AA
WWW.VONROC.COM
Machine information
Rated voltage
No load speed
No load impact rate
Chuck
Max. torque
Weight
Sound pressure level L
Sound power level L
Vibration
Model No.
Battery Type
Voltage
Capacity
Recommended charger
Weight
Model No.
Charger input
Charger output
Chargers
Charging time 2Ah battery
included
Charging time 4Ah battery
-
Recommended batteries
CD802AA
Weight
CD802AA
Model No.
CD802AA
Battery Type
Voltage
Capacity
Recommended charger
Weight
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other bat-
teries could cause serious injury or damage the tool.
CD801AA
CD803AA
20V
0-2200/min
0-3000/min
3/8" square chuck
150 Nm
1.2 kg
93.8 dB(A) K=3 dB(A)
PA
104.8 dB(A), K=3dB(A)
WA
11.15 m/s² K=1.5 m/s²
CD801AA
Lithium-Ion
20V
2.0 Ah
CD802AA
0.3 kg
CD802AA
220-240V, 50Hz 0.4A
21V
2.5A
60 minutes
120 minutes
CD801AA, CD803AA
0.36 kg
CD803AA
Lithium-Ion
20V
4.0 Ah
CD802AA
0.65 kg
20V, 2Ah Lithium-Ion
20V, 4Ah Lithium-Ion
EN
7