ENGLISH
Activation of the Smart function
Press the Function button until the Smart icon starts flashing, then press the OK button within
5 seconds to confirm your choice. If you do not press the OK button within 5 seconds, the
function will not be activated.
Deactivation of the Smart function
-
With the Smart function activated, press the Function button until the Smart icon starts
flashing, then press the OK button within 5 seconds to confirm your choice. The Smart
function will be deactivated.
-
When you activate the fast freeze function, the Smart function is automatically deactivated.
Child lock system
-
When you activate the child lock, you cannot change the temperature and function to
prevent undesired changes.
-
If you do not press any button within 3 minutes, the child lock function will be activated
automatically.
Manual deactivation of the child lock
Hold down the Unlock button for 3 seconds to deactivate the child lock.
Note
The child lock function is not available on the product with glass door.
Open door alarm
If any door is open for more than 3 minutes, the refrigerator will emit an alarm sound, which
can be stopped by pressing any key, but will sound again if the door is still open 3 minutes later.
The alarm sound will not stop until you close the door.
Function memory after a power failure
In the event of a power failure, the refrigerator will save the functions set before the power
failure and will activate them when the power is restored.
Delay start
To prevent damage to the refrigerator compressor in the event of a short power failure (i.e. less
than 5 minutes), the compressor will not start immediately after switching on.
Overheating warning (only after a power failure)
When the refrigerator cooling system is on, if the freezer compartment temperature is above
-10°C, the freezer compartment temperature digits will flash on the display. The display will
show the temperature of the freezer compartment when you press any button, and it will
return to its usual state when you press any button again or after 10 seconds.
64
Fault alarm
If the display shows E0, E1, E2, EH or EC, it indicates there has been a refrigerator failure.
Contact the Technical Support Service of Cecotec.
5. INSTRUCTIONS ON FOOD STORAGE
Use cautions
-
The refrigerator may not operate consistently (there may be some defrosting of the
contents or the temperature may become too hot in the freezer compartment if placed in
locations with a temperature out of the temperature range for which they are designed for
a long period of time).
-
The internal temperature may be affected by factors such as the location of the refrigerator,
room temperature and the door opening frequency, etc., and you should take these factors
into account if you decide to use any temperature control devices.
-
Effervescent or carbonated drinks should not be stored in the freezer compartment or
drawer of the refrigerator.
Food location
-
Due to the circulation of cold air in the refrigerator, the temperature in each zone is
different, so food must be placed in different zones.
-
The refrigerator compartment is suitable to store food that does not need to be frozen,
cooked food, beer, eggs, some seasonings that need to be kept cold, milk, fruit juice, etc.
The fruit and vegetable crisper drawer is the best place to store fruit and vegetables.
-
The freezer compartment is suitable to store ice cream, frozen foods and foods that need
to be kept for a long time.
Use of the refrigerator compartment
-
Shelves: to remove the shelves, first lift them up and then pull them out; to put them back,
put them into their position before lowering them. Keep the rear edge of the shelf facing
upwards, to prevent food from coming into contact with the wall. When removing and
fitting shelves, hold them firmly and handle them carefully to avoid damage.
-
Refrigerator compartment drawer: pull out the fruit and vegetable crisper drawer to
access the food. After using or cleaning the bottom shelf of the refrigerator (the drawer
cover), put it back in place so that the internal temperature of the drawer is not affected.
Humidity control of the drawer
-
The selector for the drawer humidity is designed to keep moisture steady and the vegetable
freshness.
-
If you slide the humidity selector to the right, more gaps will be exposed and the drawer
will have a lower humidity level.
-
If you slide the humidity selector to the left, less gaps will be exposed and the drawer will
ENGLISH
BOLERO COOLMARKET SBS 430 WHITE / INOX / DARK
BOLERO DRESSCODE TOP 80 INVERTER
65