Care And Cleaning - GE Profile XPIO13BCBT Manual Del Propietário

Care and Cleaning

To keep nugget ice tasting fresh and ice maker performing
Descaling is recommended for removing hard mineral
depending on water hardness.
Sanitizing
water, cleaning schedule may need to be adjusted based
on hardness of water.
switching to distilled water is suggested. To clean the
soft cloth dampened with soapy water to gently clean the
System Descaling / Sanitizing Procedure
4. Descaling:
instructions provided.
Sanitizing:
figure 4. After three minutes the water will stop and
NOTE:
Descaling: run the clean cycle up to 3 times and
unit is soaking, dip a cloth in the solution and wipe
cracks. When you are done, rinse the cloth with clean
water and wipe Opal again to remove any cleaning
deposits.
Sanitizing: once the Cleaning indicator turns off,
promptly drain the Opal.
49-1000464 Rev. 6
WARNING
cleaning with bleach, use bleach in a well ventilated area
WARNING
hand, and when not in use.
Clean
Hold 3 Sec
Making Ice
Defrosting
Water
Light Power
Add Water
Cleaning
7