Vaporesso GEN AIR 40 Manual De Instrucciones página 5

4. Adjust the airflow
There is a black airflow control toggle on the side
of the pod, you can adjust the toggle according
to you habits for different airflow effects.
5. Install the cartridge
Put the cartridge with installed coil onto the
battery. Make sure they are firmly connected.
6. Check the Battery Level
The LED indicators will flash while vaping to
remain the battery capacity.
0%-25% 25%-50%
7. Voltage control
Press the voltage control button to adjust voltage
by 4 stages.
3.0V
8. Charge the device
Connect the Type-C cable with the device
to charge the battery, all the LED will be on
gradually. When fully charged, all the LED
indicators will be always on.
9. Power On/Off
Press the power button 5 times within 2 seconds
to power on or power off the device.
10.Start vaping
In the locked state, hold the power button and
inhale through the Mouthpiece. Release the
power button and exhale.
50%-75%
3.2V 3.4V
Voltage
Control
Button
75%-100%
Voltage
Control
Button
3.6V
ENGLISH 3