Introduction; Device Description (Fig. A); Scope Of Delivery; Proper Use - Scheppach HS120o Traducción Del Manual De Instrucciones Original

1. Introduction

Manufacturer:
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope that your new device brings you much
enjoyment and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no
liability for damage to the device or caused by the
device arising from:
• Improper handling
• Failure to comply with the operating instructions.
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts,
• Improper use
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE0113 not being observed.
Note:
Read the whole text of the operating manual before
assembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the
device, for avoiding danger, for minimising repair
costs and downtimes, and for increasing the reliability
and extending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations
applicable to the operation of the device in your
country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must
be read and carefully observed by all operating
personnel before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
22 | GB

2. Device description (Fig. A)

1. On/off switch
2. Longitudinal stop
3. Saw blade
4. Protective cover
5. Suction hose
6. Riving knife
7. Table inlay
8. Table width extension
9. Travel fixture
10. Suction port
11. Transport handle
12. Height adjustment

3. Scope of delivery

• HS120 circular table saw
• Longitudinal stop with angle rail
• Saw blade guard with screw and wing nut
• Riving knife
• Push stick
• Table extension
• 2 table length extension supports
• 2 table width extension supports
• 2 wheel and lug units
• Saw blade ø 315 x 30 x 3.0/2 24 Z
• Saw blade key
• Push grip
• Suction hose and fastening clamp
• Enclosed accessories bag
• Operating instructions
• Open the packaging and carefully remove the
device.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the expiry of
the warranty period.
m Attention
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!

4. Proper use

The circular table saw is used for the longitudinal and
transverse cutting (only with the transverse stop) of
all types of timbers, in accordance with the machine
size. It is not permitted to cut any type of round timber.
The machine may only be used in the intended
manner.
www.scheppach.com