Additional Information; Precautions - Sony XM-1ES Manual De Instrucciones

Output Connection
Through the LINE OUT connector, this amplifier can
output signals to additional amplifiers. This allows a
flexible system connection that utilizes multiple
amplifiers.
The following shows the connections and settings
typically used to connect this amplifier to additional
amplifiers. For more details about system
connection using additional amplifiers, refer to the
operating instructions supplied with your additional
amplifier and speakers.
Note
Audio signals output from LINE OUT connectors are not
affected by any signal processing, such as the SUBSONIC
FILTER and the LPF settings.
Connection for 1-channel output
• For input connection , set the LINE OUT MODE
switch to "THRU" on the control panel.
• For input connection , set the LINE OUT MODE
switch to "ALL" on the control panel.
– Sound output from LINE OUT will be the sum of
INPUT 1 (L) and INPUT 2 (R).
Connection for 2-channel output
• For input connection , set the LINE OUT MODE
switch to "ALL" on the control panel.
– The sound from both LINE OUT 1 (L) and LINE
OUT 2 (R) will be the same.
• For input connection , set the LINE OUT MODE
switch to "THRU" on the control panel.
14
GB
Additional amplifier
Additional amplifier

Additional Information

Precautions

• This power amplifier employs a protection circuit*
to protect the transistors and speakers if the
amplifier malfunctions. Do not attempt to test the
protection circuits by covering the heat sink or
connecting improper loads.
• If your car is parked in direct sunlight and there is
a considerable rise in temperature inside the car,
allow the unit to cool down before use.
• For safety, keep the volume of the unit at a
moderate level that allows you to sufficiently hear
the sound of traffic outside the vehicle.
• Do not splash liquid onto the amplifier.
* Protection circuit
This amplifier is provided with a protection circuit
that operates in the following cases:
– When the unit overheats
– When a DC current is generated
– When the speaker terminals are short-circuited
The status indicator light will blink, and this unit
will shut down. If this happens, stop the media
playback, turn off the connected equipment and
determine the cause of the malfunction. If this
unit has overheated, wait until it cools down
before use.
If you have any questions or problems concerning
your unit that are not covered in this Operating
Instruction, consult your nearest Sony dealer.